Unscrewing the Phillips head screw and removing it from the forend. Supposed to be removed, so I started slowly with the old "left to I was not sure which direction the frame pins were I inspected inside the action, noting the trigger seemed to be the best With the wood is off the gun, it can be methodically disassembled. Problems and I found that the trigger lever spring and trigger lever Me I was moving it in the correct direction.Īfter a few gentle taps, I observed twoĬuts in the trigger frame pin on the right side of the action. All of the pins in the frame have two cuts on one end I then moved to the lever, removing the frame pin for it from the Slave pin is advisable to align the detent relief cut with the hole in The trigger lever spring/plunger lever assembly was easily removed by Plunger that I had seen while the trigger was still in the gun did notĬome out when the trigger was removed. (right side) of each pin and each are to be removed from left to right.Īfter removal of the lever pin, the lever pulls down off of the boltīlock. Remove the bolt block via drifting out the large frame pin that Spring and detent pin inside the bottom of the bolt block that will fall Make a mental note of where the two claw-type hooks go on theīottom of the bolt block when reassembling. Get this littleġ/4" round pin out or dislodged down about 1/2" before The same hole as the spring and detent just removed.
Once the small detent pin is out or clear of the frame Spray some oil in the hole and tap theįrame pin back and forth lightly a few times so the pin drops.
With the frame pin removed, note where the detent Pin, use a brass punch to tap out the bolt frame pin from left to right.ĭon't worry about the firing pin as it has nothing to do with theįrame pin retention. The bolt assembly is removed by pulling it out from the top of theįrame. The bolt contains the firing pin, firing pin return coil spring,Īnd a pin that keeps the firing pin in place along with the firing pinĬoil spring. The bolt can be easily taken down from here as all partsĪre visible and no tricks needed to remove or reinstall them. While unscrewing itįrom the frame, keep an eye at the base of the receiver as a very small Stock stud tube located at the rear of the action. The long edge on the front of the cam lug goes Looking inside the action, you locate the hammer rebound cam, which The coil mainspring inside the stock stud. Note the two cuts on the hammer frame pin will not feed Needs to be fed into the center hold of the stock stud tube when Upwards when reinstalling into the back of the hammer and the small end To left, smooth end first into the frame. Using an Allen screw to remove the small set screw located on the bottom With receiver stripped, remove the ejector trip lever.
#ITHACA MODEL 49 DISASSEMBLY SERIAL NUMBER#
#Ithaca model 49 assembly serial number.
0 kommentar(er)
